Get in touch with us
Send us an e-mail
Question What is the rotational kinetic energy of a 10-lb (4.54-kg) bowling ball (solid sphere with radius 9.50 cm) moving at 4.0 m/s? (recall: 1kg =2.205 lbs.) Answer Drop an email to support@thereliabletutor.com and get instant access to the solution. ... Read More
Reads ( 67 )| Price: Price: $0.00 | Add to Cart |
Question A one-meter in diameter holding tank, which is opened to the atmosphere, is filled with water. A four-inch line (ID) connects the bottom of the tank to a control valve, 30 feet below (assume the liquid level in the tank has negligible impact on the head). To simplify head loss calculations ... Read More
Reads ( 1720 )| Price:
Original Price: |
Add to Cart |
Question Draw a P&ID of a suitable control system around a steam condenser. Inlets of the condenser include saturated steam and a glycol liquid stream that needs to be heated. The control objective is to be able to maintain the outlet temperature of the glycol stream at a desired set point. Su ... Read More
Reads ( 880 )| Price:
Original Price: |
Add to Cart |
Question The process that occurs when a hockey goalie stops a puck is an example of feedback or feedforward control? Explain and draw the block diagram of the control system. b) List all possible disturbances that can affect the inside temperature of a house. Would a feedforward control system be ... Read More
Reads ( 1374 )| Price:
Original Price: |
Add to Cart |
Question a) List four disturbances that can affect the operation of a steam condenser. b) Draw a possible feedback control system for a) that would control the temperature of the outlet fluid being heated. Show the sensor, controller and final control element. Summary This question belongs to ph ... Read More
Reads ( 1244 )| Price:
Original Price: |
Add to Cart |
Question Explain your choice of a pressure-to-open (normally closed) or pressureto- close (normally opened) valve in the following scenarios: a) A valve on a cooling water line which is used to cool down a reactor hosting an exothermic reaction b) A valve on a water line heading to a treatment pl ... Read More
Reads ( 1116 )| Price:
Original Price: |
Add to Cart |
Question What would be the analog signal of a pressure transmitter with a range of 100 – 300 psig if the measured pressure is 227 psig? Summary This question belongs to physics and discusses about analog signal of a pressure transmitter. Word count: NA ... Read More
Reads ( 2170 )| Price:
Original Price: |
Add to Cart |
Question A process for preserving peas involves heating them quickly to a high temperature by immersion in boiling water. In a particular case, peas with an average diameter of 10.0 mm are to be heated to an average temperature of 950 C by rapid immersion in boiling water at 1000 C. the initial tem ... Read More
Reads ( 2084 )| Price:
Original Price: |
Add to Cart |
Question A double- effect evaporator is to be designed to concentrate a 5.0% (mass) NaOH solution to 30%. Steam is available at 3300F, 77.3 psia and the condensing temperature of the vapor from the lowest pressure effect is 1800 F. an initial guess for the T of the first effect results in the value ... Read More
Reads ( 1280 )| Price:
Original Price: |
Add to Cart |
Question A packed tower is to be designed to remove ammonia from an aqueous liquid stream by stripping with air. The entering liquid has an NH3 mole fraction of 0.0425 and a flow rate of 0.4 kmol/min; the gas is pure air, 80% of the ammonia is to be removed from the liquid. The figure below shows t ... Read More
Reads ( 1870 )| Price:
Original Price: |
Add to Cart |
Question If a watthour meter draws 1.5 W and 11.3 vars from a potential transformer, and 1.2 W and 1.8 vars from a current transformer, the total apparent power burden on the current transformer is Summary: This question belongs to electrostatics in physics and discusses about total apparent power ... Read More
Reads ( 751 )| Price:
Original Price: |
Add to Cart |
Question If a 0.6 accuracy class current transformer has phase angle beta of +10 at 100% rated current, the ratio correction factor is Summary: This question belongs to electrostatics in physics and discusses about class current transformer and to determine the ratio correction factor. Total word ... Read More
Reads ( 1231 )| Price:
Original Price: |
Add to Cart |
I was stuck with my fault detection in logic circuit assignment when I looked up in the net for help. Luckily I came across HwA and it was all so quick. Within 5 minutes of me enquiring for help, they mailed me back letting me know about the process. The assignment went well and since then I always consult HwA for any of my assignments.
I must confess that I was horribly bad in logic circuit designs. I just messed up the symbols and eventually my grades hampered. But whilst browsing the net I landed on HwA and ever since I started taking their help, I never had to look back. The experience hand been fantastic and I recommend all my friends to come and take help from this website.
My story with HwA started on a mid-term day, during my graduation as I was stuck with an economics assignment solution. From then onwards I constantly have obtained help from HwA and they have never disappointed me ever.
Framing the research question is the most important thing for a research paper. It provides the necessary backbone and determines the kind of research it would be. The expert here in HwA, after a deep discussion with me via email, sorted out a simple yet original research question which my professor appreciated very much.
I was having a hard time keeping up with the different assignments given by the professors and soon I was looking at the approaching deadline to submit my thermal physics assignment. The online thermal physics assignment expert at HwA delivered my thermal physics assignment essay well within the deadline and helped me pass successfully.