Chemical Engineering

Calculate Moisture Condensation And Air Drawn Into Air Conditioner

Question On a hot summer day the temperature is 35ºC, the barometric pressure is 103 kPa, and the relative humidity is 90%. An air conditioner draws in outside air, cools it ...

1600 reads$18.00$9.00
Calculate Molar Feed Stream Ratio Using Raoult’s Law

Question A liquid stream consisting of 12.5 mol% n-butane and the balance a heavy nonvolatile hydrocarbon is fed to the top of a stripping column, where it is contacted with an up...

284 reads$18.00$9.00
Calculate Molar Flow Rate Of Ideal Gas

Question An ideal gas has a pressure of 8.93 atm, a temperature of 87.30 °C, and has a volumetric flow rate of 85.39 L/min, what is the molar flow rate of the gas?   Su...

1391 reads$10.00$5.50
Calculate Molar Flow Rates Of Gases Before And After Reaction

Question Benzene (C6H6) is converted to cyclohexane (C6H12) by direct reaction with H2. The fresh feed to the process is 260 L/min of C6H6 plus 950 L/min of H2 at 100°C and 15...

1766 reads$20.00$10.00
Calculate Mole Fraction Of Propanol In Liquid And Vapor Product Stream

Question A 50/50 mixture of 1-propanol and 2-propanol is separated by a continuous single-stage equilibrium flash tank. The liquid entering the tank is at 89.0°C. The tank ope...

1199 reads$16.00$8.00
Calculate Mole Fractions Of Benzene And Bottom Product

Question Benzene and toluene are separated in a multi-stage distillation column. The feed flow rate is 100 mol s-1 and the distillate flow rate is 60 mol s-1. The reflux ratio is ...

2190 reads$15.00$7.00
Calculate Mole Fractions Of Benzene And Toluene In Vapor Phase

Question A binary liquid mixture of benzene and toluene is in equilibrium with its vapour at a pressure of 1.5 atm. The liquid mole fractions of benzene and toluene are 0.5. Show ...

1858 reads$15.00$7.00
Calculate Molecular Mass Of A Solvent

Question 5.00g of a nonvolatile compound was dissolved in 100g of water at 30°C. The vapor pressure of the solution was measured & found to be 31.20 Torr. The vapor pressu...

1402 reads$2.00$1.00
Calculating Heat Flow of Rate of Steel Pipe

Question A steel pipe having an inside diameter of 1.88 cm and a wall thickness of 0.4 cm is subjected to inside and outside surface temperature of 367 K and 345 K, respectively. ...

1272 reads$3.50$1.75
Calculate Nitrogen and Xenon Water Solubility at 50 Bar Pressure

Question Decompression sickness is caused by dissolved gases coming out of solution in the body as pressure is reduced. To remedy this, gas mixtures with lower solubility are used...

1370 reads$5.50$3.50
Calculate Normal Stress And Maximum Stresses For Spherical Caps Of A Compressed Air Tank

Question A compressed air tank is supported by two cradles as shown in the figure. One of the cradles is designed so that it does not exert any longitudinal force on the tank. The...

1431 reads$15.00$8.00
Calculate Normal Stress For A Rod With Two Cylindrical Portions

Question A rod consisting of two cylindrical portions AB and BC is restrained at both ends. Portion AB is made of structural steel and portion BC is made of cold-rolled red brass....

1458 reads$15.00$8.00